Having the USB plugged in causes the headset to receive both computer audio and communications audio as the same input therefore not allowing the built-in controller to adjust the sounds independently the communications rocker is rendered unusable and the computer audio rocker controls both. This works when I set my Trittons to default, but it only works over USB. This should set your headset to be the default while they are plugged in and return to your other speakers when they aren't.
Highlight them and set as default with the lower right button and then select apply. Plug in your headset while looking for the device that goes from Not plugged in to Ready. Refer to user documentation for that application for specific instructions.If you don't see an obvious box that can be checked to mute the speakers when headphones are connected, which you probably don't have or you would have seen it then try this: If you do not hear audio in your headset while you are in your media or other application, you may need to make the headset the default audio device within that application.Sometimes the headset is listed as a generic audio device, such as Generic USB Device or USB Audio Device. For example, you may see Plantronics USB Headset instead of. In some cases, the headset is not identified by name in the list of devices.You may need to close re-open your audio program in order for the changes to take effect.Click the Output tab, and then click your headset.
0 kommentar(er)
